What are the positive and negative impacts of living near a plain and river?
Answer:
The positive impact of living near the plain areas are-
(1) Agriculture can be carried out.
(2) Mode of transportation is convenient.
The negative impacts of living near the plain areas-
(1) Over-population
The positive impact of living near the river areas are-
(1) The land area near river are very fertile as it is rich in nutrients.
(2) Fresh water is obtained from the river and also fishing can be done in these places.
The negative impact of living near the river areas are-
(1) Flood can occur anytime, that can cause damages to lives and properties.
Choose all that apply. If you are outside during a tornado, what should you do to stay as safe as possible? get into the nearest car, and remain until the tornado passes get into the nearest mobile home, and remain until the tornado passes find a ditch and lie down flat at its lowest point, and remain there until the tornado passes get into the nearest building, and remain at the lowest level until tornado passes
Answer:
find a ditch and lie down flat at its lowest point, and remain there until the tornado passes
get into the nearest building, and remain at the lowest level until tornado passes
Answer: get into the nearest car, and remain until the tornado passes
find a ditch and lie down flat at its lowest point, and remain there until the tornado passes
Explanation: Choose all that apply. If you are outside during a tornado, what should you do to stay as safe as possible?
which bodies of water form part of the border between the United States and Canada?
What are the positive and negative impacts of living near a sea?
In the 1950s, 40 percent of the U.S. workforce was engaged in manufacturing. By the 2000s, fewer than ________ percent of U.S.
which was not a primary motivation for republicans to promote congressional reconstruction over those policies proposed by licoln and johnson
which scientist would best describe the motion of the earth
PTOLEMY
BRAHE
KEPLER
NEWTON
Answer:
Newton
Explanation:
Ptolemy usually talked about "Earth-centered," or "geocentric" theory that all celestial objects — including the planets, Sun, Moon, and stars — orbited Earth. Earth, in the center of the universe, did not move at all and obviously this theory has been proven wrong.
Brahe model had all the planets (except Earth) orbiting around the Sun, but then the Sun orbited around the Earth. This is also a wrong concept.
Kepler's Laws are mostly based upon the Planetary Motion and are incomplete is some areas.
Only Newton law best describes the motion of all planets where he says that all motion, whether it was the orbit of the Moon around the Earth or an apple falling from a tree, followed the same basic principles.
Johannes Kepler, assisted by Tycho Brahe's observations, provided the first simple and accurate description of Earth's motion, forming the basis for Newton's gravitational laws.
Understanding the Motion of Earth
When it comes to describing the motion of the Earth, Johannes Kepler would be the scientist that comes to mind. Kepler, along with the observations of Tycho Brahe, developed the first simple and accurate description of how planets move, including the Earth. Their work was foundational for the later developments by Isaac Newton in formulating the laws of gravitation, which not only explained the motion of celestial bodies but also tied it to the motion of objects falling to Earth. Kepler's laws accurately describe the elliptical orbits of planets, a significant advance from the epicycles of Ptolemy, which were circles within circles.
While Kepler's work was based on the heliocentric theory, which places the Sun at the center of the solar system as suggested by Nicolaus Copernicus, Ptolemy's model was geocentric, placing Earth at the center. The work of Kepler and Brahe was crucial in overthrowing Ptolemy's system and setting the stage for Newton's unification of celestial and terrestrial mechanics.
what language is not spoken in mainland Europe
Scientists rely on models to represent concepts and processes in physical science. Which statement best supports why scientists use models? A. Models are always colorful. B. Models only show large objects. C. Models can be taken apart to show different sections. D. Models can represent things that are too small to see
Answer:
D. Models can represent things that are too small to see
Explanation:
Scientific model is a representation to explain a fact or an observation. Scientists create models to facilitate studies and also a way to describe a phenomenon. These models form the basis of scientific knowledge because through them it is possible for scientists to represent things that are too small to be visualized, but the visualization of these things is extremely necessary for the advancement of scientific knowledge. An example of this are the models created to represent an atom and DNA, for example.
Which of the following are pressing problems for Mexico?
lack of economic development
high unemployment
lack of natural resources
low standard of living
Answer:
the answers are high unemployment, lack of natural resources, and low standard of living
Explanation:
lack of economic development is not a pressing problem for Mexico
what does earth magnetic field protect us from?
Which terms refer to major subsystems of Earth's physical systems?
If it is 5 am where you are and 7:30 pm GMT, what is your longitude
To determine the longitude based on different time zones, calculate the difference in time, which corresponds to the longitude difference.
Explanation:The question asks about determining longitude based on different time zones. When it is 5 am in the student's location and 7:30 pm GMT, we can calculate the difference in time to determine the longitude. Since each time zone is 15 degrees wide, the difference in time corresponds to the longitude difference. For example, if the student's location is ahead by 14.5 hours (which is 22.5 degrees), then the longitude would be 22.5 degrees east.
What country is opposite the United States on the earth
Suggest a reason that the time zone do not exactly follow meridians
Final answer:
Time zones do not follow meridians exactly because doing so would split regions into different zones causing inconvenience and administrative challenges. Therefore, time zone boundaries often zigzag to align with political or natural boundaries, with some countries like China choosing to operate under a single time zone for simplicity and unity.
Explanation:
Time zones do not exactly follow meridians due to practical considerations related to state, regional, and local boundaries. For example, in the United States, time zone boundaries zigzag to ensure that an entire city or state falls within the same time zone. This avoids confusion and inconvenience, as well as helps with economic and social unity within distinct regions.
China, in contrast to the segmented time zones of the United States, has chosen to use a single time zone across the whole country, even though its land area spans several conventional time zones. This centralization is also rooted in administrative efficiency and national unity.
The original concept, as proposed by Sir Sanford Fleming in 1878, was to have 24 time zones each 15 degrees of longitude apart, which would correspond to one-hour increments based on Earth's rotation. However, keeping to such a rigid system would require constant readjustment of time with every minor movement east or west. To address this issue, time zones were broadened to strips roughly 15 degrees wide but adjusted to accommodate human activity and governance.
David has a piece of wood measuring 1218 feet that he wants to use for a project. He needs to cut the wood into pieces that measure 11316 feet. How many pieces of wood can he cut measuring exactly 11316 feet?
David can cut 10 whole pieces of wood measuring exactly 11316 feet from a piece of wood measuring 1218 feet after converting both measurements to inches and dividing the total length by the piece length.
Explanation:Calculating Pieces of Cut WoodTo answer the question: David has a piece of wood measuring 1218 feet that he needs to cut into pieces measuring 11316 feet each. To determine how many pieces he can cut, it is necessary to convert both measurements to a common unit, such as inches, and then divide the total number of inches in the wood by the number of inches in the pieces he wants to cut.
First, convert 1218 feet to inches: (12 feet × 12 inches/foot) + (18 inches) = 144 inches + 18 inches = 162 inches. Next, convert 11316 feet to inches: (1 foot × 12 inches/foot) + (316 inches) = 12 inches + 3.75 inches = 15.75 inches. Now divide the total number of inches in the wood by the number of inches each piece should be: 162 inches ÷ 15.75 inches. The result is approximately 10.29.
Since David can't cut a fraction of a piece, he can only cut 10 whole pieces of wood measuring exactly 11316 feet.
Hurricanes vs tornadoes
Final answer:
Hurricanes develop over warm water, while tornadoes come out of severe thunderstorms.
Explanation:
Hurricanes develop over water that is warmer than 80 °F. As the air heats, it rises rapidly, drawing incoming air to replace the rising air and creating strong wind currents and storm conditions. The rapidly rising humid air then cools and condenses, resulting in heavy rains and a downdraft of cooler air. The rotation of the earth causes the storm to rotate in a cyclonic pattern. North of the equator, tropical storms rotate in a counterclockwise direction. South of the equator, tropical storms rotate in a clockwise direction.
Tornadoes come out of severe thunderstorms called supercells, which have a column of air rotating around a horizontal axis. The difference in wind speeds between the strong cold winds higher up in the atmosphere and weaker winds traveling north from the Gulf of Mexico causes the column of rotating air to shift so that it spins around a vertical axis, creating a tornado.
What is the slope of the perpendicular line to = + 3?
A. -1
B. 0
C. 1
D. -3
San Francisco's relative location, shown on this map, contributed to its importance by allowing the city access to
A) a bay.
B) parks.
C) a river.
You have learned that earth lithosphere is made up of many plates.How do you think this fact might help scientist solve the mystery of the moving continents
The government of Belgium provides three community councils to protect the interests of
The correct answer is A) the major ethnic and language groups in the country.
The other options of the question were B) immigrants to Belgium. C) those who move from Brussels to Flanders. D) minorities who move from Belgium to neighboring countries.
Belgium provides three community councils with the intention to protect the major ethnic and language groups in the country because they have their owm interests.
Belgium is a first world country in the middle of the European continent that has a division of territory according to the languages they speak there. They have regions of Dutch-speaking, German-speaking, and French-speaking. Only a minority are multilingual and live in the center of the territory.
south america is in the western hemisphere
true false
The natinal hurricane center uses the Slosh model to
The weathering of the Earth's surface is known as CORROSION.
True
False
Answer:
false
Explanation:
Why have corporations in the United States outsourced communication jobs to countries such as India?
A) no labor restrictions in India
B) availability of cheap labor in India
C) availability of native English speakers
D) loss of jobs in the US of native speakers of English
US corporations outsource jobs to India because of the country's low labor costs and large, educated, English-speaking workforce, which makes it an efficient and cost-effective outsourcing destination within a globalized trade environment.
Explanation:Corporations in the United States have outsourced communication jobs to countries like India primarily due to the availability of cheap labor. Labour costs in India are significantly lower than in the US, which makes it financially beneficial for companies looking to reduce expenses. Additionally, India offers a large pool of educated individuals who are fluent in English, making it an ideal location for customer service and technical support roles that require proficiency in the language.
Another factor contributing to outsourcing is that India has a high number of skilled or educated workers who can be trained for service-industry tasks. This skilled labor base coupled with high-speed communication links, enables efficient and cost-effective outsourcing for US companies. Furthermore, the trend of globalization has made outsourcing more common, with trade agreements facilitating international business and companies seeking to maximize profits by reducing costs.
1. ¿Por qué es importante la energía solar?
The SCALE shows the relationship between distance on a map & on the Earth's surface. Question 1 options: True False
what type of map is best suited for maritime navigation
Where is population increasing more rapidly?
A. LDCs
B. MCDs
Blake ran around the gym.His times are shown in the table.Blake is trying to decide whether the number of laps is proportional to the time.Find his mistake and correct it.
His mistake is that he has already covered 2 laps but did not include them.
What are ratio and proportion?A ratio is a collection of ordered integers a and b represented as a/b, with b never equaling zero. A proportionate expression is one in which two items are equal.
Blake ran around the gym.
His times are shown in the table.
Blake is trying to decide whether the number of laps is proportional to the time.
The time T is directly proportional to the number of laps N.
N ∝ T
If the sign of proportionality is replaced with an equal sign, then a constant k is introduced.
N = kT
Then the value of k will be
N = 2T
But the equation is not satisfied. So add 2 on the right side, then we have
N = 2T + 2
More about the ratio and the proportion link is given below.
https://brainly.com/question/14335762
#SPJ5