Saturn, Of the planets listed, Saturn is the greatest distance from the Sun. As a result, Saturn receives little of the Sun's warming energy and has a relatively cold surface temperature.
Answer:
The answer is C. Saturn
Explanation:
I had this question on stusdy lsland.
What might happen to the mass and/or the distance between two objects to increase the gravitational force of attraction?
What makes silver and gold different by using the terms atom and element
The difference between silver and gold is that they are different elements with different atoms.
An atom is the smallest unit of matter that retains all the properties of an element. Gold atoms cannot be broken down into anything smaller while still retaining the properties of gold.
An atom is the smallest unit of matter that retains all of the chemical properties of an element. Gold atoms cannot be broken down into anything smaller while still retaining the properties of gold. Gold is classified as an element, which means it is a substance composed of only one type of atom.
The fastest plane ever made, the Lockheed SR71, was able to travel 2200 miles per hour. Based on this speed, how far can it travel in 2 hours, 3 hours, and 5 hours?
The distance traveled by the plane in 2 hours, 3 hours, and 5 hours are:
4400 miles6600 miles11000 milesWhat is speed?Speed is the distance travelled per unit. Mathematically, it can be expressed as:
Speed = distance / time
How to determine the distance in 2 hoursSpeed = 2200 mphTime = 2 hDistance =?Distance = speed × time
Distance = 2200 × 2
Distance = 4400 miles
How to determine the distance in 3 hoursSpeed = 2200 mphTime = 3 hDistance =?Distance = speed × time
Distance = 2200 × 3
Distance = 6600 miles
How to determine the distance in 5 hoursSpeed = 2200 mphTime = 5 hDistance =?Distance = speed × time
Distance = 2200 × 5
Distance = 11000 miles
Learn more about speed:
https://brainly.com/question/680492
#SPJ2
An atom with an atomic number of 12 and a mass number of 25 can best be described by which of these?
A) An atom that contains 12 protons and 13 neutrons.
B) An atom that contains 13 protons and 12 neutrons.
C) An atom that contains 12 protons and 25 neutrons.
D) An atom that contains 25 protons and 12 neutrons.
Answer:The awnser is A
Explanation:
Just did the test
Which term describes the relationship between wax and wane
The term that describes the relationship between wax and wane is "phases." Waxing and waning refer specifically to the phases of the Moon.
The term that describes the relationship between wax and wane is "phases." Waxing and waning refer specifically to the phases of the Moon. The Moon goes through a repeating cycle of phases, transitioning from a new moon (not visible) to a waxing crescent, first quarter, waxing gibbous, full moon, waning gibbous, third quarter, and finally waning crescent before returning to a new moon again.
Waxing describes the Moon's illumination increasing while waning describes the Moon's illumination decreasing.
To know more about the waxing and waning:
https://brainly.com/question/32862855
#SPJ6
Reactants → Products
In the picture, which box on the right is the correct products according to the Law of Conservation of Mass?
A) A
B) B
C) C
D) D
Answer: D) D
Explanation: According to the law of conservation of mass, mass can neither be created nor be destroyed. Thus the mass of products has to be equal to the mass of reactants. The number of atoms of each element has to be same on reactant and product side. Thus chemical equations are balanced.
As the atoms should remain conserved thus there should be 3 yellow atoms, three red atoms and 4 blue atoms in the products.
Thus the correct option is D.
is the following sentence true or false.. winds blowing inland from oceans carry less water than winds blowing from land
Julie is an amateur astronomer. Using her telescope, she observes a planet that has large rings with beige and reddish bands. What is Julie most likely observing?
a solid inner planet
a gaseous outer planet
a gaseous inner planet
a solid outer planet
A gaseous outer planet. It has rings so she is most likely looking at Saturn which is a gaseous outer planet with rings.
Which of the following elements has the highest atomic mass?
1. Helium: 2 protons and 2 neutrons
2. Nitrogen: 7 protons and 7 neutrons
3. Oxygen: 8 protons and 8 neutrons
4. hydrogen: 1 proton and no neutrons
Answer:
Oxygen has the highest atomic mass out of all the four elements.
What does the force diagram look like for a book at rest on a desk?
The strength of the electric field of a charged particle becomes greater as the distance from the particle increases. True or false
The strength of the electric field of a charged particle becomes greater as the distance from the particle increases. this statement is False.
What is electric field ?Electric field is field around electrically charged particle where columbic force of attraction or repulsion can be experienced by other charged particles. It is denoted by letter E and it's SI unit is V/m Volt per meter or N/C newton per coulomb. Electric field comes inward to the center of the negative charge and it is going outward for positive charge. Electric field E is given by E = F/q where F is columbic force experienced by the unit charge.
Electric around a charge having magnitude q is given by
[tex]E = \frac{1}{4\pi r^{2} } \frac{q}{r^{2} }[/tex] where r is the distance from the center of the charge.
from formula we can see that as distance increases electric field decreases because electric field is inverse function of distance r.
Hence above statement is false.
To know more about electric field :
https://brainly.com/question/15800304
#SPJ2.
A truck accelerates at 5m/s2. Find the truck's mass if the driver applies a force of 425N(can you also show free diagram)?
which is an element A. titanium and carbon in an alloy B. oxygen and nitrogen joined together C. a water molecule D. a piece of pure nickel
ps its science
a soccer ball is kicked with a speed of 15.6m/s at an angle of 32.5 degrees above the horizontal. If the ball lands at the same level from which it was kicked for what amount of time was it in the air?
Answer:
Time of flight, t = 1.71 seconds
Explanation:
It is given that,
Speed of the soccer ball, u = 15.6 m/s
Angle made with the horizontal, [tex]\theta=32.5^{\circ}[/tex]
Let t is the time for which the ball was in the air. The time duration for which the ball is in air is called the time of flight of the projectile. It is given by :
[tex]t=\dfrac{2u\ sin\theta}{g}[/tex]
[tex]t=\dfrac{2(15.6)\ sin(32.5)}{9.8}[/tex]
t = 1.71 seconds
So, the ball was in the air for 1.71 seconds. Hence, this is the required solution.
To find the amount of time the soccer ball was in the air, we can break the initial velocity of the ball into its horizontal and vertical components. The time in the air can be calculated using the vertical velocity component and the vertical distance traveled.
Explanation:To find the amount of time the soccer ball was in the air, we can break the initial velocity of the ball into its horizontal and vertical components. The horizontal component will remain constant throughout the motion, while the vertical component will change due to the force of gravity.
Using the initial velocity of 15.6 m/s and the angle of 32.5 degrees above the horizontal, we can find the vertical velocity component using trigonometry. The vertical velocity component is given by Vy = V * sin(θ), where Vy is the vertical velocity, V is the initial velocity, and θ is the angle above the horizontal.
With the vertical velocity component, we can calculate the time the ball was in the air by dividing the vertical distance it travels by the vertical velocity. Since the ball lands at the same level, the vertical distance can be assumed to be zero. Therefore, the time in the air is given by Δt = 2 * (Vy / g), where Δt is the time in the air, Vy is the vertical velocity component, and g is the acceleration due to gravity (approximately 9.8 m/s²).
20 POINTS!!!!
What Rock Would You Be?
Over time, rocks transform from one type to another through the geological processes that occur on Earth. Consider this fact as you read and respond to this lesson's discussion prompts.
Imagine that you are a rock. What type of rock would you be and where would you be located—for example, would you be deep within the Earth or on the surface?
What were you like before you became the rock you are now and what type of rock will you be in the future?
Be sure to describe the processes involved in the changes you have gone through to get to where you are now, as well as the changes you will undergo as you change your rock type again.
Look at Tyler's post:
I am a piece of a sedimentary rock sitting here in the crust. I used to be a magnificent metamorphic rock, but over time, I was weathered down to small pieces by the wind. I became sediment and then was covered by other sediments. In time, I was cemented together with these sediments as they pushed against me with more and more pressure. As the rocks continue to pile on top of me, I will get pushed further underground. Eventually, I will melt and become igneous rock. I know this because it has happened before. It's all part of the rock cycle.
Metamorphism often occurs on two scales: contact and regional. Contact metamorphism occurs relatively locally, in areas adjacent to igneous intrusions or in areas that are in contact with hot water known as hydrothermal fluids.
Typically this kind of metamorphism is caused by moderate pressure and extreme heat that may last for a period of days to thousands of years. In cases of contact metamorphism, the most extreme metamorphism occurs at the contact point between the parent rock and the intrusive magma or hydrothermal fluid. The degree of metamorphism then decreases rapidly as distance from the heat source increases. Depending on the source, zones of contact metamorphism may range from a few millimeters to tens of meters.
In contrast to contact metamorphism, regional metamorphism occurs over much larger areas. In areas such as rising mountain ranges, large igneous intrusions can form and warp overlying strata increasing the pressures above the intrusion. Also the extreme heat and pressures caused by tectonic forces or deep burial will cause widespread metamorphism.
and here's a link(you cant report me because i took a picture of the link, so ha-ha)
If the amplitude of the resultant wave is twice as great as the amplitude of either component wave, and this wave exhibits reinforcement, the component waves must
A. have a different frequency than the resultant wave.
B. be in phase with each other.
C. be traveling in the opposite direction of the resultant wave.
D. have a different wavelength than the resultant wave.
Answer: B-be in phase with each other
If the amplitude of the resultant wave is twice as great as the amplitude of either component wave, and if this wave exhibits reinforcement, the component waves must be in phase with each other.e
A package of supplies is to be dropped from an airplane so that it hits the ground at a designated spot near some campers. The airplane, moving horizontally at a constant velocity of 130 km/h, approaches the spot at an altitude of 0.520 km above level ground. Having the designated point in sight, the pilot prepares to drop the package. (a) What should the angle be between the horizontal and the pilot's line of sight to the drop point when the package is released? (Neglect air resistance)
a substance that contains only one kind of matter is known as a (n)
explain why a fast moving freight train cannot be stopped quickly
What building material did you use to build your house? Did your results support or fail to support your hypotheses?
Answer:
Wood Cement base boards
Explanation:
The building material which is required to build our house is cement, wood, and pillars.
Which building material?
Building materials are required to build a house. Wood, aggregates, and cement are some examples of building materials. Some natural materials are the clay, sand and rocks are some of the examples of building materials.
Types of construction materials are:
Natural construction material.FabricMud and clay.Rock BrushMetalConcrete.Plastic pipes and metal pillars are required to build a building. The process of building is called construction. If the building materials are good the quality and durability of houses increases.
Therefore, The building material which is required to build our house is cement, wood, and pillars.
To learn more about building materials, refer to the link:
https://brainly.com/question/17943868
#SPJ2
A homeowner installs an electrical heated mirror into the shower room. When a person has a shower, the heated mirror does not go misty but stays clear, why?
how many stars are in the sky
The fastest speed in the universe is the ____________ _____ ______________.
Hi there! Can someone help me out please?
Please add details to support your idea.
Thanks!
Emily sprains her ankle on her way home from school. Her mom suggests she use an “instant cold pack” to reduce the swelling. When Emily’s mom hands her the cold pack, it is room temperature. The instructions on the pack tell Emily to pop a button inside the ice pack to open a packet of chemicals. Once Emily has popped the button, she notices that the cold pack immediately gets cold. She places it on her swollen ankle. Write a thoughtful and complete response (3+ sentences) that describes what happened to the energy as it is first in the cold pack (before Emily pops the button), then when she pushes the button, and then after Emily has placed the cold pack on her ankle. Discuss transfers and transformations of the energy.
Why is it more important to monitor your word choice in a professional environment
A dog is sniffing around for a bone. He walks 3.6 m east and 6.0 m north. What are the magnitude and direction of the dog from his original position?
When analyzing the results of a scientific experiment, Kevin should base his conclusion on
Answer:
the empirical evidence that is collected during experiment.
Explanation:
When analyzing the result of any scientific experiment, we should base our conclusion on the evidences during process of the experiment. Because conclusion of any experiment describe the important things we noticed during experiment and all such steps are combined and give us the result of experiment. so Kevin should base his conclusion on the empirical evidences during experiment.
Why is energy needed to break chemical bonds
a student walks 3 miles west and then 4 miles south to get to school the student displacement was
We have that a student walks 3 miles west and then 4 miles south to get to school the student displacement was
D=7miles
From the question we are told
a student walks 3 miles west and then 4 miles south to get to school the student displacement was
Generally the equation for the displacement is mathematically given as
D=intial travel +final Travel
Therefore
D=3+4
D=7miles
Therefore
A student walks 3 miles west and then 4 miles south to get to school the student displacement was
D=7miles
For more information on this visit
https://brainly.com/question/12319416?referrer=searchResults